Plano Tru-Trainer return
For the alignment of the return side of the Belt. The systemflat return TRU- TRAINERmakes use of a unique and highly effective positioning action that does not damage thecobands Conveyorand to lean in if thecobandsConveyor starts getting out of its center. Because it does not depend on contact with the edge of the Belt to guide it, it is thus avoided to damage that end of the Belt, very common in the case of other alignment systems.
TRU- TRAINERhas special cones (similar to those of a crown-type polea) on the external edges that make the drum of theTRU- TRAINERturn on an internal vertical pivoting axis. The central internal pivoting axis is perpendicular to the tape, which makes the positioning action always remain on the same horizontal plane as the Belt.
Because of that,TRU- TRAINERIt also works well with reversible and vaiven conveyors.
Benefits:
- Easy
- installation Under maintenance
- Vibration-free rolling action
- Simple design
- No contact with the edge of the Belt
- The bearings are not jammed, when they are located insideof the mechanism.
- With mends adjustable to any systemtransporter.
- It works under all conditions
- Opera with reversible tapes
- It can be installed inside or below the Belt
The bearing compartment is located at both ends of the roller to provide support in all its length, ensuring a vibration-free concentric rotation. EachTRU- TRAINERuses a pair of 6017 2RS bearings to facilitate the design (internal movement of the axis inside the inner shirt), and therefore it is perfectly within its RPM and load specifications, allowing for the alignment of Conveyor Belts with speeds exceeding 7 m / s The central pivot axis is unique and simple, and consists of a stainless steel pin within a solid, sealed soft steel central axis for life.
Benefits:
- Easy installation and low maintenance. By permanently aligning the Belt towards the center of the transporter, reduces damage to the edges, spills and improves the operation performance of the entire transporter.
- Design for heavy work. 3-7 / 16 ″ bearings, 1 ¼ axis»with a hot vulcanised abrasion-resistant rubber-coated roller. Ceramic and urethane coverings are also available.
- It works on the top or bottom deck of the Belt.
- Total Satisfaction Guarantee. To solve alignment problems and make the conveyor system operate more efficiently.
