Tru-Trainer Cargo Artisa
For the alignment of the load side of the cobands Conveyor. For obvious reasons, a different positioning configuration was required by virtue of the canned nature of this side of the conveyor belt. Adjustable side rollers were incorporated to ensure effective contact with the lower edge cover Belt, 25 - 55 ° instead of the usual 90 °, compatible with all stations between 15 ° and 45 °.
The side rollers are installed from 5 to 10 mm to each of the corrugated edge of the Belt. The central roller pivot which is approximately 2 / 3 of the width of the Belt, works under the same principles as the TRU-TRAINER return flat which reacts immediately when the Belt conveyor is removed from its central axis by keeping it focused.
Benefits:
- Easy installation, under maintenance, simple design, no contact at 90 degrees with the edge of the tape. By permanently aligning the Belt towards the center of the transporter, reduces damage to the edges, spills and improves the operation performance of the entire transporter.
- It works under all types of dry and wet conditions, it adapts to any type of configuration of load articles between 15 and 45 ° thanks to its adjustable side rollers.
- Total Satisfaction Guarantee. To solve alignment problems and make the conveyor system operate more efficiently.
Principles of operation:
- The first rule is that the Belt moves to the end of the roller that touches first.
- The beauty of this patented system worldwide is its simplicity. The crown-shaped roller has a pivot in the center that rotates laterally on exactly the same plane that uses the Belt.
- As Belt starts moving out of its central axis the chaflanada edge (slightly convex shape, crown type) comes into contact. Due to the lower diameter at the edges a change of forces occurs, making the Tru- Trainer pivot forward to the same side to which the Belt, which naturally makes the next meters of Belt first contact the opposite end by focusing the Belt.
- The Tru- Trainer should be installed with its perpendicular mends at the advance of the Belt, in order to ensure that the pivot turns the roller forward and back instead of up or diagonal.
